引用本文:[点击复制]
[点击复制]
【打印本页】 【在线阅读全文】【下载PDF全文】 查看/发表评论下载PDF阅读器关闭

←前一篇|后一篇→

过刊浏览    高级检索

本文已被:浏览 40次   下载 66 本文二维码信息
码上扫一扫!
胶合竹植筋深度及直径对抗拔性能的影响
严彦,刘焕荣,聂玉静,张秀标
0
(国际竹藤中心,北京100102; 安徽太平试验中心,太平245716;浙江农林大学工程学院,临安311300)
摘要:
采用胶合竹梁、双组份环氧树脂胶黏剂,不同直径和长度的公制螺纹杆,进行胶合竹顺纹双端植筋拉伸试件制备及测试,初步分析研究了植入深度和植筋杆直径2个因素对胶合植筋强度和破坏模式的影响。抗拉试验破坏模式主要为植筋杆的拔出破坏和螺纹杆的韧性断裂破坏2种模式,其中植筋杆的拔出破坏位于胶合竹/胶黏剂界面;胶合竹顺纹双端植筋的破坏载荷及名义剪切强度随螺纹杆直径和植入深度增加而增大;胶合竹基材较胶合木基材渗透性差,植筋杆受力不能很好地传递到竹材内部,是影响抗拔载荷主要因素之一。
关键词:  胶合植筋  胶合竹  影响因素  抗拔强度  破坏模式
DOI:10.13610/j.cnki.1672-352x.20150302.029
基金项目:国际竹藤中心基本科研业务费专项资金(1632011002, 1632015013)资助。
Effects of the glued-in threaded rod depth and diameter on the connection strength of structural glued laminated bamboo
YAN Yan,LIU Huanrong,NIEYujing,ZHANG Xiubiao
(International Center for Bamboo and Rattan, Beijing 100102; Anhui Taiping Experimental Station, Taiping 245716;School of Engineering, Zhejiang A & F University, Lin’an 311300)
Abstract:
Through the both-end pullout test on the glued-in threaded rods in bamboo plywood, the effects of the depth and the diameter of the embedded rods in the bamboo glulam on the connection strength and the failure modes were investigated. Two failure modes were identified during the pullout test: the fracture of threaded rods and the pullout failure of the rods that existed in the interface between bamboo and the adhesive. The pullout critical load and the normal shear strength of both-end glued-in rods in bamboo plywood increased with an increase of the diameter and embedded length of the threaded rods. In addition, the low stress transfer efficiency caused by the poor permeability of bamboo is the main reason for hindering the further improvement of the connection strength of bamboo plywood composites.
Key words:  epoxy bonded steel connection  bamboo plywood  impact factors  pullout strength  failure mode

用微信扫一扫

用微信扫一扫